We offer higher strength Belts manufactured with N/N and EP Fabric, In General Duty and Heavy Duty types subjected to tensile loads. In selection Process Choosing the right Strength Belt is very important because conveying material fed scrapers, plows, creates an impact load on the belt.

Our Conveyor Belts have properties of high Wear and tear resistance, As belt scrapers, plows, and other cleaners create wear as they rub over the belt surface. The belt should thus have a high wear resistance to survive in tough conditions.

As we Know higher elongation in the belt reduces the tension created in the belt. This would reduce the power transmitting capacity , We offer Low elasticity and minimal elongation Belts Confirms to IS 1981 (Part I,II)

They should have a good flexibility in the longitudinal and lateral planes. In many cases, belts are made to run over many pulleys. The belt material should have the necessary flexibility to mould over the idlers.

Belts are made from plies, which are bonded with a rubber element. The bonding of the plies should be such that it doesn’t separate out due to the repeated bending of the belt over the pulleys.

In Beneficiation Plants water gets absorbed by the belt increases the weight of the belt. This would result in increased power consumption and reduced conveying capability. It also gives more dimensional stability of the belt.

Humidity, extreme heat or cold. The belt material should be good enough to ensure that it works with optimum results under such working environmental conditions